The Cuttlebug Spot Challenge: Oh Baby

Here’s another challenge card, and again I am getting it done just in time before the challenge ends.  This card is for this for The Cuttlebug Spot.

There is no Cricut on my card this time — it is all done on the Cuttlebug.  I was able to use up some scraps with this card.  The main cut, the bird and the joyriding baby, is made from a Boss Kut die.  The die is titled Joy Ride.  This was my first time using a Boss Kut die in my Cuttlebug and I was happy with how it cut — no problems at all.  I inked around the edges of the cut pieces. 

The trim at the bottom is done with the Martha Stewart Lattice Heart deep edger punch.  I ran the cardstock through the Cuttlebug using the Swiss Dot embossing folder before I cut it with the punch.  The sentiment is from Cuttlebug, the Welcome Baby Emboss Combo.  The corners are from Cuttlebug’s Vintage Die Set and I added some pearls to each one. 

This card went together pretty fast and I’m pleased with how it turned out. 

Front of Joy Ride

 The two small safety pins on the inside of the card with made with Cuttlebug’s Baby Die 2.

Joy Ride Inside

• Boss Kut Joy Ride die
• Cuttlebug Welcome Baby Emboss Combo, Vintage Die Set, and Baby Die 2 by Provo Craft
• Cuttlebug Swiss Dot embossing folder
• Martha Stewart Lattice Heart deep edger punch
• Pearls and ink